- #Error 6001 pro tools interface how to
- #Error 6001 pro tools interface install
- #Error 6001 pro tools interface 64 Bit
Prior to that, LAWICEL CANUSB used PID FFA8. Please note if you are using an older unit: In February 2015 we have updated CANUSB settings to use the standard FTDI USB PID. The code support is still in the DLL, but we do not support it. Please note we dropped support for Callbacks since it doesn’t work well, we have not found a solution for this yet. CANUSB uses Layer 2 of OSI model, so any HLP could be added on top of that, but we do not make such software. We do not make/provide any HLP (Higher Layer Protocol) DLL/Software such as CANopen, DeviceNet, J1939 etc. This is not machine dependent, it is application dependent.
#Error 6001 pro tools interface 64 Bit
Choose either 32 bit or 64 bit DLL depending on what you shall develop or what the 3rd party program uses.
#Error 6001 pro tools interface install
Download the zip package, unzip and run setup to install the CANUSB DLL (do not run setup within the zip file). Our CANUSB DLL uses the FTDI USB D2XX DLL together with our ASCII protocol. Accessing the unit over FTDI's D2XX DLL works much faster, though.įinally, the CANUSB DLL is a library that adds functions for opening, closing, sending & receiving CAN frames easily and there is also a DLL wrapper for C#. The VCP mode makes it particularly simple to test the CANUSB with a terminal software. The simple ASCII protocol can be accessed directly through the FTDI D2XX DLL or - if enabled - using the VCP (Virtual COM port) mode. That means, CANUSB can work with just the FTDI USB drivers. In a next (optional) step the CANUSB DLL can be installed or the VCP mode of the FTDI chip can be enabled. The USB driver for the FTDI interface chip (as contained in the adapter) must be installed first and it is usually installed automatically by Windows when plugging in the CANUSB (for old CANUSB units produced before 2015 please see below for special instructions). You as a developer of your own software/application can choose which level/path you want. You as an end user need to find out which drivers to install if you use a software made by a 3rd party developer, check with them for more information. Also remember, if you only need one ID or one group of IDs, set both masks to the same, so the unwanted CAN frames do not slip through the second filter!ĬAN Acceptence Filter for 11bit IDs using Dual Filter ModeĬAN Acceptence Filter for 29bit ID’s using Dual Filter Modeīelow is a block diagram showing drivers you need to install to get CANUSB to work properly (some are optional) in Windows. When using 11 bit IDs this means it is possible to accept only one ID, but when using 29 bit IDs it is not possible to mask the whole ID. When using dual filter mode, it is possible to set two regions of CAN IDs.
#Error 6001 pro tools interface how to
We have prepared two documents to show how to set these filters for both 11 bit IDs and 29 bit IDs. For more information on how acceptance filters work please refer to the SJA1000 data sheet pages 44-48 and SJA1000 application note pages 19-22 (AN97076).ĬANUSB uses dual filter mode (single filter mode is not availible). For a description of the two available modes please refer to the sections below.ĬANUSB User Manual How to use Acceptance FiltersĬANUSB uses the SJA1000 CAN controller. The CANUSB User Manual linked in below describes the adapter and the ASCII protocol which can be used to access the device in serial mode. Manuals, Drivers, Example Software and Projects for the LAWICEL CANUSB Latest Documents CANUSB User Manual
0 kommentar(er)
